A little trick you can use when you think you have come across a misaligned flange. No special tools needed, just the key to your house! We recently came across this flange during a process walkdown and pointed it out. Some folks wanted to debate whether it was misaligned. I was 100% confident it was […]
3-way valves have grown in popularity over the past 10-15 years, as they have begun to find their way into relief systems. Today, codes allow “relief trees” to be used, so Pressure Safety Valves can be changed out without emptying and degassing the vessel. The 3-way valve is the means by which the PSV is
Another crazy question that I was asked a few weeks back by a friend and up-and-coming safety pro. Again, the side bar group discussions ALL said NO, the authorized employee doing the LOTO must be the one to verify ZES of the LOTO, not the “affected employee” who has nothing to do with the LO
This debate has been going on amongst a number of us, as a friend asked the question. 99% of of agreed – NO, it can not be reclassified when the COM DUST is inside the space. Cleaning it would be a Permit-Entry; once clean AND FREE of the COM Dusts, then we could discuss reclassifying
If you can’t tell, I am having a ball playing with these AI systems. And to be honest, my numbers were a bit more conservative than Gemini and Grok, but darn, they were excellent answers that are SOLID nonetheless. These AI tools may make amazing tools for PRE-PLANNING for Pool Fires and FOAM INVENTORY needs.
My question: How much water flow in GPM is necessary to cool a 1,000 gallon LPG tank that is involved in a pool fire to prevent it from experiencing a BLEVE? Their answer… Google Gemini is learning who I am! Given your work with SAFTENG.net, you likely know that while 55 GPM is the “engineering”
Yes, there are two (2) types of BLEVEs, and much like the myth that BLEVE’s only happen to Pressure Vessels with liquified flammable gases, COLD BELVEs account for nearly 25% of all BLEVEs. So what is the difference between the two? Super GROK explains it better than I could… A BLEVE (Boiling Liquid Expanding Vapor
I continue to play with and test Google Gemini Plus and Super GROK in the OSH and Process Safety space. Today, my question to both was: How much of a Class II flammable liquid will it take to burn under a 1,000-gallon LPG tank to cause a BLEVE? BOTH of the systems had outstanding answers!
I wrote about “focusing on our fundamentals” this week, which generated a lot of discussions offline amongst my friends and clients. The number 1 question asked was “What should we score in 2026?” My response was “at least 95%”. That means that in 100 LO inspections, we should have a failure rate across ALL items
I am not sure who, where, and when this dirty little lie began, but we have been seeing an incorrect application of NFPA 70, 500.7(K) Detection System for Flammable Gases, item (3) Interior of a Building or Enclosed Space. It seems businesses are looking for any way out of having an electrically classified area and many are
We routinely find facility siting issues when LPG Tank(s) and Flammable Liquid Tank(s) are located in the same area. OSHA, NFPA, IFC, etc., all require a separation distance between the two (2) types of tanks. This is ALL about preventing a setup for a BLEVE, as a pool of flammable liquid finding its way under
An ammonia system at an industrial food processing facility over-pressured, activating one of its overpressure safety relief valves. Ammonia was released into the atmosphere for approximately eight (8) minutes until the refrigeration compressor was manually shut down by disconnecting the supply power, and the pressure in the system was reduced. INVESTIGATION CONCLUSIONS
