ex-dev

Comparison of Piping Inspection Requirements in Refrigeration Industry Code Component Description Inspection Remediation Inspection Frequency IIAR 109 (1997) Uninsulated Pipe (4.7.4)   Examine for corrosion Clean pipe down to bare metal and paint with rust preventative paint. “Badly corroded pipe should be replaced.”  (4.7.4) – Annual ammonia safety check (5.2) – Thorough inspection every 5 years (5.3)  …...

Comparison of Pressure Vessel Inspection Requirements in the Refrigeration Industry Code Type of Inspection Component Description Inspection Remediation Inspection Frequency IIAR 109 (1997) All pressure vessels If signs of more than mild corrosion should inspect further by a professional engineer or ASME inspector (4.3.5) None listed – Annual ammonia safety check (5.2) – Thorough inspection every 5 years (5.3) IIAR 110 (1993) Including…...

The following are all the “exemptions” permitted in EPA’s Risk Management Plan rule (40 CFR PART 68—Chemical Accident Prevention Provisions)… Membership Required You must be a member to access this content.View Membership LevelsAlready a member? Log in here...

Below is OSHA’s official position on the need for hydrostatic relief valves in an Ammonia Refrigeration process.  This is a bold move on OSHA’s part as the Ammonia Refrigeration industry and their trade groups have consistently stated that a “trained operator” is better than a hydrostatic RV. (emphasis added by me)… Membership Required You must...

Retail facilities are exempted from PSM requirements.  At first glance, it appears this is a pretty broad exemption, as the standard just states. This section does not apply to:1910.119(a)(2)(i) Retail facilities; But as I wrote about last month, not all retail facilities selling a PSM Highly Hazardous Chemical (HHC) in the USA are exempt. In…...

Jan 26, 2006  – An accident occurred in a factory in Brazil during pneumatic pressure testing with air from pipework around a tank.  There were no blind flanges placed to isolate the pipework to the tank; only the valves were closed. Probably one or more valves failed or were not closed as the tank underwent…...